echo Error: Cant read configuration file >&2. MAXPWM=hwmon4/pwm4=255 hwmon4/pwm3=255 hwmon4/pwm1=255Īny ideas? I'm probably doing something quite stupid, would appreciate any advice. Simple script implementing a temperature dependent fan speed control. Recommended configuration for VR Gaming PC. MINSTART=hwmon4/pwm4=45 hwmon4/pwm3=45 hwmon4/pwm1=60 enhances the read/write speeds of the device to match that of SSDs. Running fancontrol Reinitialization after suspend to RAM/Disk Links Introduction Ubuntu can monitor CPU and other system temperatures, fan speeds, and voltages via command line, using the package lm-sensors, or via GUI applets in your desktop. MINTEMP=hwmon4/pwm4=30 hwmon4/pwm3=30 hwmon4/pwm1=30 1 23:06:23 bastri Member Registered: Posts: 16 Hi, I enabled the service rvice and started it but when I executed: fancontrol this error is displayed: userlocalhost > sudo fancontrol sudo password for user: Loading configuration from /etc/fancontrol. configuration from /etc/fancontrol Error: Cant read configuration file Now based. My /etc/fancontrol config file is set up with: # Configuration file generated by pwmconfig, changes will be lostĭEVPATH=hwmon4=devices/platform/nct6775.656įCTEMPS=hwmon4/pwm4=hwmon4/temp2_input hwmon4/pwm3=hwmon4/temp2_input hwmon4/pwm1=hwmon4/temp2_inputįCFANS=hwmon4/pwm4=hwmon4/fan4_input hwmon4/pwm3=hwmon4/fan3_input hwmon4/pwm1=hwmon4/fan1_input Re: Guide for fan speed control for Nvidia cards in Linux Sat Nov 09. I have identified my three fans as pwm ports 1,3 & 4.Įvery time I want to start the service, using sudo service fancontrol start, I receive the error message: * Not starting fancontrol, broken configuration file please re-run pwmconfig. My issue is, now that I want to control this with fancontrol, I can't seem to create an appropriate configuration file when I run sudo pwmconfig. configuration from /etc/fancontrol Error: Cant read configuration file. configuration from /etc/fancontrol Error: Cant read configuration file. The Setup edit can be used to control the fanCheck Fan speed in Linux Mint. To do this, I had to add nct6775 to '/etc/modules' for the purpose of starting the the appropriate module to read from the nuvoTon chip. Acer Nitro AN515-54 fan speed control laptop is burning up. Since most of you are going to use pwmconfig (8) script, the config file syntax will be discussed last. Alternatively you can write this file yourself using the information from this manpage. I've recently been trying to get my fans automated on my Asus H87-Pro Motherboard. For easy configuration, there's a script named pwmconfig (8) which lets you interactively write your configuration file for fancontrol.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |